wyrestorm ex-1utp-ir-70-amp 70m hdbt extender/amplifier

Brand New Transmit. Receive. Amplify. Extend. The WyreStorm EX-1UTP-IR-70-AMP is a single cable extender set, and then some. Comprising of a Class B 70m HDBaseT transmitter with bidirectional control via IR and RS232 and the award-winning WyreStom HDBaseT Digital Amplifier as the receiving device, the EX-1UTP-IR-70-AMP enables a single HDMI source to be distributed over distance, with the flexibility of the AMP offering superior audio and control capabilities at the display zone. The inclusion of the AMP as a receiving device also opens up further opportunities to extend transmission over HDBaseT up to 7 times for scalable single source distribution, with each display point benefiting from two-way IR, addressable serial control along with 3:1 audio switching including local audio input, ARC and 25w 2.1ch audio functionality of the AMP – all over a single Cat5e/6 cable. Features Transmits 1080p HD @60Hz and HD multichannel audio from a single HDMI source up to 70m/230ft under recommended conditions * HDMI Input > HDBaseT Output, HDBaseT Input > HDBaseT / HDMI Output Combined HDBaseT Transmitter, Receiver, Repeater and Class D audio amplifier – all-in-one Discrete wide-band bidirectional IR control and fully addressable serial control of AMP via signal transmitted together within the HDMI signal over a single Cat5e/6cable to control source, display and AMP. RS232 Commands (Tx, Rx, Gnd) sent with HD Audio & Video contained within single Cat5e/6 Centralized RS232 for firmware updates or third party control with open source integration protocols available for market leading control systems 3:1 Audio switching/receiver – Audio from centralized source via HDBaseT Transmitter Audio Return Channel (ARC) or Local Audio Input via 3.5mm AMP may be used centrally with AV source, In-line close to speakers, wall mounted near data connections or locally at display location Fully cascadable up to 7 times to further lengthen transmission and increase your distribution capabilities - 70m/230ft to AMP > a further 70m/230ft to additional AMP x 7 HDMI output for direct connection of HD display either in-line to each AMP connected or at the end of the run 2.1 stereo audio at 25w per channel with left/right spring terminal connections for speakers RCA Subwoofer output connection EDID management and pre-sets via DIP switch LED indication for visual power, video signal status, audio source selection - HDBaseT, Local or ARC Fully supports 3D applications (frame sequential – Blu-ray and Interlaced Stereoscopic – Satellite/cable broadcasts) Supports 36bit Deep Colour HDBaseT Transmitter powered by 5v mains adapter or with the 5v USB power cable to solve space or power availability problems at source location as well as being more energy efficient as the transmitter is only powered when the source is turned on. 50m/164ft Power-over-HDBaseT Passthrough to PoH enabled display receivers HDMI V1.4 Cable termination follows IEEE-568B standards HDCP compliant Automatically adjusts feedback, equalization and amplification of signal for easy installation. Accessory pack including configuration software, remote, IR receiver Compact size for flexible integration location For more information please check out wyrestorm.com/catalog/EX-1UTP-IR-70-AMP